Wednesday, 10 October 2018

Researchers develop 3D printed objects that can track and store how they are used

Engineers have developed 3D printed devices that can track and store their own use -- without using batteries or electronics. Instead, this system uses a method called backscatter, through which a device can share information by reflecting signals that have been transmitted to it with an antenna.
at
Labels:

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

How 'clean' does a quantum computing test facility need to be?

How to keep stray radiation from 'shorting' superconducting qubits; a pair of studies shows where ionizing radiation is lurking and ...

  • Arduino MCP2515 CAN Bus Interface Tutorial
    In this project, we will learn about the MCP2515 CAN Controller Module, how to interface the MCP2515 CAN Bus Controller with Arduino and fin...
  • Logic Gates And How They Work
    I was first introduced to logic gates when I was around 14 years old. I had heard that computers consisted of ones and zeroes. But I didn’t...
  • MOSFET Gate Resistor
    Do you need a MOSFET gate resistor? What value should it be? And should it go before or after the pulldown resistor? If you’re a bit impati...