Tuesday, 16 July 2019
Resistance is utile: Magnetite nanowires with sharp insulating transition
Scientists have produced Fe3O4 nanowires on 10-nm length scales by deposition on an MgO substrate. When cooled to 110 K, the nanowires showed a sharp Verwey transition -- greater resistivity resulting from a change in crystal structure. This switching is essential for nanoelectronics, but hard to achieve in Fe3O4 nanowires. It was possible because of the low density of antiphase boundary defects, and will promote advances in green electronic technologies.
Subscribe to:
Post Comments (Atom)
Researchers develop recyclable, healable electronics
Electronics often get thrown away after use because recycling them requires extensive work for little payoff. Researchers have now found a w...
-
Do you need a MOSFET gate resistor? What value should it be? And should it go before or after the pulldown resistor? If you’re a bit impati...
-
In this project, we will learn about the MCP2515 CAN Controller Module, how to interface the MCP2515 CAN Bus Controller with Arduino and fin...
-
In this project, I will show you how to build an Arduino Wattmeter, a device that can be used to measure the power consumed by a load. In ad...
No comments:
Post a Comment