Thursday, 3 October 2019
Printed electronics open way for electrified tattoos and personalized biosensors
Electrical engineers have devised a fully print-in-place technique for printable electronics that is gentle enough to work on delicate surfaces ranging from paper to human skin. This can be accomplished without additional steps to bake, wash or powder-coat materials. The advance could enable technologies such as high-adhesion, embedded electronic tattoos and bandages with patient-specific biosensors.
Subscribe to:
Post Comments (Atom)
-
Do you need a MOSFET gate resistor? What value should it be? And should it go before or after the pulldown resistor? If you’re a bit impati...
-
I was first introduced to logic gates when I was around 14 years old. I had heard that computers consisted of ones and zeroes. But I didn’t...
-
In this project, I will show you how to build an Arduino Wattmeter, a device that can be used to measure the power consumed by a load. In ad...
No comments:
Post a Comment