Thursday, 17 September 2020
Sturdy fabric-based piezoelectric energy harvester takes us one step closer to wearable electronics
Researchers presented a highly flexible but sturdy wearable piezoelectric harvester using the simple and easy fabrication process of hot pressing and tape casting. This energy harvester, which has record high interfacial adhesion strength, will take us one step closer to being able to manufacture embedded wearable electronics.
Subscribe to:
Post Comments (Atom)
-
Do you need a MOSFET gate resistor? What value should it be? And should it go before or after the pulldown resistor? If you’re a bit impati...
-
In this project, we will learn about the MCP2515 CAN Controller Module, how to interface the MCP2515 CAN Bus Controller with Arduino and fin...
-
In this project, I will show you how to build an Arduino Wattmeter, a device that can be used to measure the power consumed by a load. In ad...
No comments:
Post a Comment